ZR-50W CO2 power supplies
Feature
1. This ZR-50W CO2 power supply adopts G/P/L/G/IN/5V as control signal output port with 5V/24V output and use gray aluminum case.
2. This 50w laser power supply has stable performance: Each co2 power supply has been much more rigorous testing procedures, under full load high temperature (52~55 degrees Celsius) 24 hours of aging, to ensure the stability of each50w laser power supply.
3. Laser power control is simple on this 50w laser power supply, you can use 0 ~ 5V analog signal control the laser power, you can also use the PWM (pulse width modulation) signal to control output laser power.
4. Good compatibility: This PWM/0-5V laser power supply can match with most brand 1000mm 50W CO2 laser tube and it also has a strong adaptability and fast response, engraving, cutting advantages of good effect.
5. Control is simple: This co2 laser power supply selects high or low level control, the use of TTL-level control of the laser can start and stop. At the same time it increases the protection switch, testing is through the external water and ventilation on this PWM/0-5V laser power source.
6. Protection function: This PWM/0-5V laser power supply has open circuit protection: Under the condition of good protective earth, the50w laser power supply can work in open-circuit for a short time, which could avoid the damage to this PWM/0-5V laser power supply.
Specification
|
lnput |
Input voltage |
AC220V ±10% (AC110V specified while order) |
||
|
|
AC frequency |
47~440HZ |
||
|
|
Maximum input power |
370W |
||
|
|
Maximum input current |
1.7A |
||
|
Output |
Maximum output voltage |
25KV |
||
|
|
Maximum output current |
25mA (depending on the laser tubes of different manufacturers) |
||
|
Efficiency |
More than 90% (Full load) |
|||
|
Response speed |
Not more than 1ms |
|||
|
Control lnterace |
TTL multilevel switching control,effective level can be high and low selection (see control wining diagram) |
|||
|
Insulation |
lnput-output |
AC 1500V 1 minutes not more than 10mA |
||
|
|
lnput-shell |
AC 1500V 1 minutes not more than10mA |
||
|
|
Output-shell |
Connection |
||
|
Open Circuit Protection |
Can be short circuit (requires a good grounding shell,while avoiding the positive electrode and the shell between the arc) |
|||
|
Environmental Requested |
Working temperature |
-10 ℃~50 ℃ |
||
|
|
Storage of temperature |
-20 ℃~75 ℃ |
||
|
|
Relative Humidity |
Maximum 85%RH (non-condensing) |
||
|
|
Altitude |
100,000 feet of work 200,000 feet of storage,dose not work |
||
|
Cooling methods |
Forced air cooling (fan cooling) |
|||
|
Dimensions (LxWxH) |
162mmx145mmx97mm |
|||
