BOOSTER TO TODDLER SEAT

Removable & dishwasher safe tray

3 point harness

Easy to fold

Can fit most chairs

Read all instructions before use of the booster to toddler seat.

Keep these instructions manual for future reference.

Keep small parts away from children.

6 months to 4 years old. Maximum Weight 40 lbs.

INSTRUCTION MANUAL

Thank you for buying the Booster to Toddled Seat from DOL-BE Infant. This innovative product can be used as a traditional booster which allows your child to sit at the table and eat with family members.

Adjustable settings accommodate your growing child. As the child gets older, it can be used as a toddler seats for playtime. The folding design is convenient and perfect for traveling.

WARNING:

PREVENT serious injury or death from falls or sliding out.

NEVER leave child unattended.

ALWAYS secure child using restraint straps.

The tray is not designed to hold the child in the chair.

ALWAYS secure BOTH back and chair straps.

NEVER allow child to push against table.

NEVER lift this product with your child in it.

Read all instructions before use of the product.

Keep instructions for future use.Do not use this product if it is damaged or broken.

Use ONLY for a child that can sit up unassisted.

NEVER use this product as a car seat or bath seat, on a table or counter top, stool, swivel chair, or any other chair where the straps cannot secure it properly.

NEVER adjust the height while your child is in it.

CAUTION:

KEEP SMALL PARTS OUT OF CHILD'S REACH.

SET UP:

Pivot arms up by pulling arms out and then up. See Figure A.

Pivot back into position and snap down into the locks on both arms rests, one arm at a time. See Figure B.

Secure rear strap around back of kitchen chair. See Figure C.

Secure strap to bottom of chair. See Figure D.Place child in seat and secure with 3 point harness. See Figure F.

NOTE: Depending of chair type, side straps may be moved to the rear position if needed. See Figure E.

TO ADJUST HEIGHT:

NOTE:Never adjust height with child in the Booster Seat.

If using booster seat on chair, unsnap rear strap buckles from chair.

Push up the knob located under the seat. See Figure G. Raise or lower seat to desired heights. Make sure legs lock into place once seat is at the desired height.

NOTE: This product was intentionally designed to be challenging when adjusting heights. While pressing the knob under the seat, place hand on back seat handle and lift up and back when adjusting height positions of the seat. See Figure H.

Turn knob under seat counter clockwise 90 degrees to prevent additional height adjustment.

Secure rear strap around back of chair.

TO USE WITH TRAY:

For children who do not sit at the table, a large tray is included that attaches easily to the seat with one simple step.

Slide tray on from the front. Make sure it locks into place.See Figure I.

To remove, pull up the two locking tabs underneath and slide off.

TO USE AS A TODDLER CHAIR:

To use as a toddler chair follow these easy steps after the initial set up.

Adjust height of the seat to the highest setting. See Figure J.

Turn knob under seat counter clockwise 90 degrees to prevent additional height adjustment.

Remove the three strap system on the seat (optional). See Figure K.

Snap on the small tray and small cup to the sides of the arm rests. See Figure K.

TO FOLD:

Push the button located at the back of the arm and lift seat up to release the back. Repeat for other arm.

See Figure L.Fold the back down towards the seat. See Figure L.

Fold in arms onto seat back. See Figure M.

Push knob underneath seat and release height to its lowest setting. See Figure N.

Take strap from chair bottom and wrap it around the folded seat.

Lock and tighten strap for easy and safe transport or storage. See Figure O.

TO CLEAN:

The X-Frame Booster Seat can be cleaned easily by wiping it down with soapy water and rinsing it off.