| Thickness and material Quality of drum sheet |
Drum Camber Is Made | From 7-8 mm Thick 1 Outlet 4 mmAnd Inlet | |||||||
| HELIXS Are Made From 4 Mm Thick EREĞLİ 9435 A1quality Steel Material |
|||||||||
| Drum pulley system | Single roller is 280 mm in diameter GGG 60 special SPHERO Casting and intouch with the ring at 2 points and have wavering s ys t em s . |
||||||||
| Drum turning speed 0-15 rot/min. Has handle control and fixed turning rate. | 0-15 rot/min. Has handle control and fixed turning rate. | ||||||||
| Drum rotation command system | Mechanical controlled (left and right) and has a speed control | ||||||||
| Water tank | It is made from 4 mm thick S235 JR quality steel material with a | ||||||||
| Capacity | of 800-1000 liters | ||||||||
| Water pump | There are" 1½" inlet and outlet and operates by a gearbox. | ||||||||
| Cooling system | By hydraulic cooler. | ||||||||
| Hydraulic hose | Hydraulic pressured and made by MANULI/ ITALY. | ||||||||
| P.t.o system | Operates by truck PTO system. | ||||||||
| Gearbox | ZTS MPV72,1 I TRANSMITAL 577 | ||||||||
| Hydraulic pump type | Sauer MVH112/R2D1A ( HYDROSILA) | ||||||||
| Hydraulic motor type | Sauer MVH90/2C1181 ( HYDROSILA) | ||||||||
| Oil cooler | 24 volt rasa radiator. | ||||||||
| Mixer chassis | Chassis is made by using S235 JR quality NPU profile as 10 mm thick outer (160x70x70 mm) part and 10 mm thick inner (140x70x70 mm) part which total 20 mm in thickness. |
||||||||
| Front and behind consoles | Front and behind consoles are made from 7-8 mm thick S235 JR Quality material |
||||||||
| Bolts | Bolts are 8.8 quality | ||||||||
| Truck fender | Lightened and high corrosion resistant plastic (imported) | ||||||||
| Extension chute | Filler "V "type and turning chutes are made from 4 mm thick S235 JR quality material extension chute is in front of turning Chute with size of 70 Cm. There are 2 pcs additional plastics Chutes. |
||||||||
| Chute lifting jack | It is hydraulic system and imported. | ||||||||
| Sand blasting and painting | After sand blasting with grits ,2 K double components epoxy Primary coats are applied. Then 2K acrylic auto paints will be Applied and trans mixers will be dried in furnace. |
||||||||
