Self adhesive bitumen flashing tape is a self-adhesive, aluminum or high density

polyethylene surfaced bitumen & SBS rubber backed sealing strip. It is a quick, efficient

and cost effective method of flashing, sealing and repair that produces a lasting protection

in all climates.

 CHARACTERISTIC

Self-adhesive without bonding agent, torching

Good self-coalescence

Safe application, no pollution

Corrosion resistance and ageing-resistance

Provides an instant seal

Easily applied by hand pressure only

Available in wide range of widths, thickness, colors

 TYPICAL USES

GENERAL:

Vehicle maintenance and repair, sealing around pipes and tanks, repairs to weatherproof

enclosures, sealing over wood, concrete brick most metals and some plastics.

CONSTRUCTION:

*Replacement or repair of flashing * Gutterring, down pipes. Skylights

*Extensions, porches. Window frames & chimneys

*Caravans & Conservatories *Sealing parapets, Valley gutters

Thickness: 1.0MM, 1.2MM, 1.5MM

Width: Available in 50 mm,75 mm,100 mm,150 mm,200 mm,225 mm,250 mm,300 mm

450mm etc

Length: 2.5 m,3.0 m, 5.0 m,1 0m,20 m

Special sizes made to order

 STORAGE

Store under cover, out of direct sunlight and protect from extreme temperature. In tropical

climates the product must be stored in an air-condition environment. Shelf life is up to 12

months when stored as per recommended storage condition.

 HEALTH & SAFETY

As with all bitumen products caution should always be exercised. Protective clothing such

as gloves and goggles should be worn. Treat any splashes to the skin or eyes with fresh

water immediately. Should any of the product be accidentally swallowed, do not induce

vomiting, but call for medical assistance immediately.

 APPLICATION

1 Make sure the surface smooth, clean, no dust or other loose material

2 Cut the flash band t to required length

3 Remove the release paper. Press flash band into place, using fingertip pressure. Avoid

excessive pressure

4 When laying adjacent rolls the flash band must overlap by at least 25mm

5 Use a seam roller or rounded piece of wood to smooth the flash band and ensure good

contact is made

 Overpainting:

Flash band can be overpainted with conventional decorative paints, though a little staining

may occur at the edges.

 Note:

In cold weather, application will be made easier by warming the surface and by storing